Elektrostatik-sonde  –  til NFA -apparatene
Elektrostatik-sonde – til NFA -apparatene

Enkel spenningstester, ser ut som en skrutrekker#Zur Überprüfung des phasenrichtigen Anschlusses von Elektrogeräten.

kr 2 690 Add to my Cart
Forsterker (low noise) til Biolog Antenne
Forsterker (low noise) til Biolog Antenne

Forsterker (low noise) til Biolog Antenne

kr 4 500 Add to my Cart
Frekvensfilter FF10
Frekvensfilter FF10

Det er dette filteret som gjør den store forskjellen! En 40-60 dB rensing av uønskede frekvenser så vel som den 20-30 dB filtreringen av den teknisk sværet vanskelige separeringen mellom GSM/LTE1800 og DECT.  Til å festes mellom antennekabelen og antenneinngangen.

For an exact analysis of the major radio services in Europe (including the three LTE frequencies as well as TETRA).

Frequency range: (Here: filter positions) Allpass / low pass 480 MHz / TETRA / LTE800 / GSM900 / GSM / LTE1800 / DECT / UMTS / LTE2600 / WLAN

kr 8 975 Add to my Cart
Frekvensfilter FF3
Frekvensfilter FF3

FF3 er et bånpass filter tilpasset instrumentene HF35C og HF38B. Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på instrume.
Til HF 35 C, HF 38 B, HF 58 B, HF 59 B.

#Service-specific frequency filter FF3 Recommended for: HF35C, HF38B. The service specific filters always only show the preset radio service, and suppress all other frequencies.
Evaluates each radio service separately
* To be connected between the antenna cable and the antenna input socket of the measurement device (by the operator).
* Cascadable with all amplifiers and attenuators.
* Also allows a broadband measurement without additional transmission loss, which means the filter can remain attached to the measurement device.
* Comprises the most common sources of radiation.Very good selection of the chosen radio services.
* Possible exposures to sheath currents on the cable behind the filter can be additionally suppressed with the help of a free of charge modification of your HF-device. Please do not hesitate to contact us.

Frequency Range:  ALL / GSM9 / GSM18 / DECT / UMTS / WLAN
Accuracy:  Typical suppression of unwanted frequencies : > 25-30 dB, GSM1800 vs. DECT eff. 20-30 dB.
Power supply:  9 V battery

kr 3 980 Add to my Cart
Frekvensfilter FF6
Frekvensfilter FF6

FF6 er et lav- høy- og bånpass filter anbefalt for HF58B og HF58B-r. Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på inst.

# Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på instrumentet direkte verdien for denne strålingskilden.>Måler lavpass, høypass (1,1 GHz), GSM900, GSM1800, DECT,UMTS og WLAN.

Info Engl.
Evaluates each radio service separately

Additional features as compared to the FF3:
    * The 50-60 dB suppression of unwanted frequencies is unequalled in this product segment. It allows for a precise analysis of the selected frequency ranges.
    * An additional high pass filter applied at 1100 MHz helps differentiating in areas with high levels in the TV bands.
    * To be connected between the antenna cable and the antenna input socket of the measuring device (by the operator).
    * Cascadable with all amplifiers and attenuators.
    * Also allows for a broadband measurement without additional transmission loss, which means the filter can remain attached to the device.
    * Perfectly shielded against interferences.
    * Possible exposures to sheath currents on the cable behind the filter can be additionally suppressed with the help of a free of charge modification of your HF-device.

kr 4 950 Add to my Cart
Frekvensfilter FF6 E  til HFE 35C, HF35 og HFE 59B etc
Frekvensfilter FF6 E til HFE 35C, HF35 og HFE 59B etc

FF6E er et lav- høy- og bånpass filter anbefalt for HF E 35C og HF E 59B. Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avlese.

# Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på instrumentet direkte verdien for denne strålingskilden Måler allpass;lavpass (1,1 GHz), høypass (1,1 GHz), GSM900, GSM1800, DECT,UMTS og WLAN Tetra og DVB-T.

Engl. Info:
Evaluates each radio service separately.
Additional features as compared to the FF6: The 50-60 dB suppression of unwanted frequencies is unequalled in this product segment. It allows for a precise analysis of the selected frequency ranges.
With its additional filters for TETRA-BOS, DVB-T, as well as high and low pass combinations applied at 1100 MHz this filter is especially suited for our E-type measuring devices (as from 27 MHz).
To be connected between the antenna cable and the antenna input socket of the measuring device (by the operator). Cascadable with all amplifiers and attenuators.
Also allows for a broadband measurement without additional transmission loss, which means the filter can remain attached to the device.
Perfectly shielded against interferences.
Possible exposures to sheath currents on the cable behind the filter can be additionally suppressed with the help of a free of charge modification of your HF-device.

Technical data:
Frequency Range: ALL / GSM9 / GSM18 / DECT / UMTS / WLAN / HP11/ TP11 /TETRA / DVB-T
Accuracy: Typical suppression of unwanted frequencies: > 50-60 dB, GSM1800 vs. DECT eff. 20-30 dB.
Power supply: 9 V NiMH battery, average time of operation: 8 hours, Low-Batt. indication, auto-power-off-function, mains adaptor, battery charger.

kr 5 980 Add to my Cart
GPS boks for UBB antenne, med tilbehør
GPS boks for UBB antenne, med tilbehør

UBB27_SA3 Quasi isotrop ultra bredbåndsantenne

Boks som stativ for UBB antenne : kan da brukes som mottaker med GPS, i forbindelse med NFA serien. Med alle nodvendige kabler som tilbehør.

# Forutsetter at man har en UBB antenne fra før: Det er den samme antennen som følger med eller kan kjøpes som tilbehør til flere av Gigahertz sine måleinstrumenter, men dette settet er tilpasset bruk sammen med spektrum analysatorer, NFA serien og GPS.
Frequency Range:  27 MHz to beyond 3.3 GHz.
Weight:  0,67 kg

kr 6 490 Add to my Cart
HF Isotrop antenne UBB 2410
HF Isotrop antenne UBB 2410

Soon available HF Isotrop antenne UBB 2410 Istrop Ultra Bredband antenne

kr 3 450 Add to my Cart
Høyfrekvens-forsterker HV10  (HF 58B, 59B)
Høyfrekvens-forsterker HV10 (HF 58B, 59B)

Høyfrekvens-forsterker HV10 (HF 58B, 59B)

RF-preamplifier HV10_27G3 suitable for: HF58B, HF59B, HFE59B

 

kr 1 490 Add to my Cart
Høyfrekvens-forsterker HV20 (HFW35C og HFW 59B)
Høyfrekvens-forsterker HV20 (HFW35C og HFW 59B)

RF-preamplifier suitable for: HFW35C, HFW59B. #

Increases
the sensitivity of the HF-analyser by a factor of 100 (= 20 dB).
Adaptor plug to be connected to the antenna input socket, remote-fed by
the respective basic device.

Technical data:
– Further Questions:  Two years warranty
– Weight: 0,04 kg

Scope of delivery:
– Amplifier
– tightening aid
– manual

kr 1 490 Add to my Cart
Høyfrekvens-forsterker HV30 (HF58-r), HF(E) 59B
Høyfrekvens-forsterker HV30 (HF58-r), HF(E) 59B

RF-preamplifier suitable for: HF58B, HF58B-r, Hf59B.#

Increases the sensitivity of the HF-analyser by a factor of 1000 (= 30 dB). Adaptor plug to be connected to the antenna input socket, remote-fed by the respective basic device.
Further Questions:  Two years warranty
Weight: 0,03 kg

Scope of delivery:
– Amplifier
– tightening aid
– manual

kr 1 490 Add to my Cart
Høypass filter HP800_G3
Høypass filter HP800_G3

High-pass filter suitable for: HFE35C, HF59B, HFE59B.#

The HP800 increases the measuring accuracy when measuring with the log.-per. antenna in combination with the extremely broad band devices HFE35C and HF59B(Filter included in the scope of supply of the HFE59B).
Why?
The log.-per. antennae are sensitive also for individual frequencies below the specified frequency range. These can be successfully suppressed with the filter, which in turn allows a significantly improved analysis of the measurements with a log.-per. antenna, as the measurements are not impaired by unidentified interference signals.

– This filter helps suppress the lower frequencies. It reaches an attenuation of more than 50 dB (= factor 100,000) below 600 MHz.
– All Gigahertz analysers specified above 800 MHz already come with a similar filter integrated in the basic device. This integration naturally makes no sense for the HFE-types.
– Adaptor plug to be connected to the antenna input socket.

Technical data:
– Accuracy:  Attenuation: 10 MHz – 600 MHz < – 50 dB
– Pass band: 0 Hz, 800 MHz – 3000 MHz = -1 dB +/- 0.5 dB
– Return loss: > 12 dB
– Further Questions: Two years warranty
– Weight: 0,03 kg

Scope of delivery:
– High-pass filter
–  tightening aid
– manual

kr 1 290 Add to my Cart