Beskrivelse
Datalogger for proffe HF og 3D-LF Analyzer
Datalogger for proffe HF og 3D-LF Analyzer
kr 790
USB data logger EL-USB3
for HF + LF devices!
USB data logger stick for the recording of the DC output of our measuring devices. Easy-to-operate software for a graphical evaluation of the measured values included.
» DC-voltage data logger.
» suitable for HF58B, HF58B-r, HF59B, ME3851A, ME3951A and NFA series.
» To be connected with an optional Gigahertz-produced adapter cable (Logkab1+2 / 38,20 Euro).
» Logging rate adjustable from 1 s to 12 hours.
» Memorizes 32,000 measured values,voltage measuring range DC 0 to 30V
På lager
Related Products
Dirty electricity Pakke 5 (20 filtere)
Skittenstrømfilterene demper støy fre det elektriske anlegget ved at den fjerner uheldige frekvenser som rir på de rene sinusfrekvensene i strømnettet. Det er særlig sparepærer, lysstoffrør og alt av elektronisk utstyr som lager disse frekvensene. Skittenstrømen måles med en skittenstrømmonitor som puttes i vegguttaket. Man legger til filtere i den sammme kretsen til den ønskede effekten er oppnådd.
HF Analyzer HFW 59 B (høyfrekvens 2,4-10 GH, meget proff)
HF Analyzer HFW 59 B (høyfrekvens 2,4-10 GH, meget proff)
Frekvensfilter FF3
FF3 er et bånpass filter tilpasset instrumentene HF35C og HF38B. Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på instrume.
Til HF 35 C, HF 38 B, HF 58 B, HF 59 B.
#Service-specific frequency filter FF3 Recommended for: HF35C, HF38B. The service specific filters always only show the preset radio service, and suppress all other frequencies.
Evaluates each radio service separately
* To be connected between the antenna cable and the antenna input socket of the measurement device (by the operator).
* Cascadable with all amplifiers and attenuators.
* Also allows a broadband measurement without additional transmission loss, which means the filter can remain attached to the measurement device.
* Comprises the most common sources of radiation.Very good selection of the chosen radio services.
* Possible exposures to sheath currents on the cable behind the filter can be additionally suppressed with the help of a free of charge modification of your HF-device. Please do not hesitate to contact us.
Frequency Range: ALL / GSM9 / GSM18 / DECT / UMTS / WLAN
Accuracy: Typical suppression of unwanted frequencies : > 25-30 dB, GSM1800 vs. DECT eff. 20-30 dB.
Power supply: 9 V battery
Målekoffert MK20 (ME3080 & HF 35 C (høy- og lavfrekvent)
Målekoffert MK20 (ME3080 & HF 35 C (høy- og lavfrekvent)
Frekvensfilter FF6
FF6 er et lav- høy- og bånpass filter anbefalt for HF58B og HF58B-r. Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på inst.
# Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på instrumentet direkte verdien for denne strålingskilden.>Måler lavpass, høypass (1,1 GHz), GSM900, GSM1800, DECT,UMTS og WLAN.
Info Engl.
Evaluates each radio service separately
Additional features as compared to the FF3:
* The 50-60 dB suppression of unwanted frequencies is unequalled in this product segment. It allows for a precise analysis of the selected frequency ranges.
* An additional high pass filter applied at 1100 MHz helps differentiating in areas with high levels in the TV bands.
* To be connected between the antenna cable and the antenna input socket of the measuring device (by the operator).
* Cascadable with all amplifiers and attenuators.
* Also allows for a broadband measurement without additional transmission loss, which means the filter can remain attached to the device.
* Perfectly shielded against interferences.
* Possible exposures to sheath currents on the cable behind the filter can be additionally suppressed with the help of a free of charge modification of your HF-device.
HF Analyzer HF 35C (Måler høyfrekvens)
Dette er apparatet for de tekniske
amatører. Apparaet gir en enkel evaluering av høyfrekvent stråling, og
har en audiofunksjon som gjør at man kan høre strålingsmengden.
Apparatet gir og en visning av toppverdier i tillegg til
gjennomnittsverdier.#
This is THE device for technical amateurs –
especially easy to operate. It allows a straight forward assessment of
the exposure, a determination of suitable remedial actions, as well as a
control of their effectiveness.
Even this starter device already
combines all common advantages. The reading shows the total pollution
without any calculation required. The measured values are reliably
displayed directly in the entity corresponding to the building biology
standard values. An acoustic signal proportional to the field strength
with «Geiger-counter-effect» helps identifying regions with increased
exposure. Digital display of 1 µW/m2 up to 1999 µW/m2.
Frequency Range: 800 MHz – 2.5 GHz
Measurement Range: Power flux density: 1 – 1999 µW/m2
Accuracy: Basic accuracy including linearity tolerance : +/- 6dB Zero offset and rollover +/- 9 digits
Sensor: Logarithmic periodic antenna
Audio Analysis: acoustic signal proportional to the field strength with «Geiger-counter-effect»
Signal rating: peak value
Power
supply: 9 Volt alkaline manganese battery (included), average operation
time 10 – 12 hours Low-Batt. indication, auto-power-off
HF Analyzer HF 59 B (Måler høyfrekvens, proff)
Vårt førsteklasses HF-apparat.
Apparatet har en ekstra bred frekvensrespons, og funksjonene er
beregnet på å møte behovene innen byggebiologien.#
Due to its
extra broad frequency response, this basic device is predestined for an
extension with the UBB27 and for detailed, professional analyses. Its
functions and features are tailored to the needs and practical
experiences of the building biology. Due to its comparably low price, it
is often also used for scientific and industrial purposes – mostly as
kit called HF E 59B – especially in the sector of EMVU and product
development (precompliance).
In addition to the full functionality of the HF58B-r:
–
A frequency range of down to 27 MHz within the basic device – suitable
for the connection of the optionally available antenna UBB27_G3 (the
scope of delivery includes a compensated antenna for 800 MHz up to 2.5
or 3.3 GHz).
– A calibrated extra AC-measurement output for the demodulated signal, and a scalable DC-output.
–
HINT: If you only need to measure above 800 MHz the HF58B-r is the
cheaper and better solution for you. Only with the antenna UBB27
(included in the kit HFE59B) you can in fact measure frequencies below
800 MHz (e.g. digital TV, TETRA, new GSM Channels in Europe).
Technical Data:
–
Frequency Range: A frequency range of down to 27 MHz within the basic
device – suitable for the connection of an optionally available antenna
(the scope of delivery includes a compensated antenna for 800 MHz up to
2.5 or 3.3 GHz)
– Measurement Range: Power flux density: 0.01 – 19,990 µW/m²
– Accuracy: Basic accuracy including linearity tolerance : +/- 3dB
Zero offset and rollover +/- 5 digits
–
Sensor: Optimised logarithmic periodic antenna with frequeny
compensation directly on the antenna: Less ripple, better
directionality, improved shielding vs. ground, continuous LED-monitoring
of quality of connections
– Audio Analysis: Identification of pulsed
radiation sources (mobile radio (GSM, UMTS/G3), cordless telephones
(DECT), WLAN (Bluetooth), air-traffic control radar) by means of an
acoustic signal proportional to the modulation frequency
– Electric power supply: Rechargeable highpower 9.6 Volt NiMH battery pack inside the meter, average operation time: 7 – 8 hours
Low-Batt. indication, auto-power-off
AC-adaptor for charging and long-term-operation included
Signal Rating: Display of peak value, peak hold as well as average value (switchable)
–
A quantitative differentiation between pulsed and un-pulsed radiation –
a unique feature within the broadband measuring technology
– Outputs: A calibrated extra AC-measurement output for the demodulated signal, and a DC-output.
Scope of Delivery:
– Measurement device
– attachable log.-per. antenna incl. cable
– NiMH battery inside the meter
– mains adaptor
– battery charger
– detailed instructions manual
– plastic case.
IEC strømkabel-skjøteledning, skjermet og jordet – hvit
IEC power connection cord C13(CE)
1,00 mm2, 3 meters, white