Beskrivelse
K5 Romslig Plastkoffert for 2 måleapparater
K5 Romslig Plastkoffert for 2 måleapparater
kr 260
Grei, liten koffert med plass og god beskyttelse for to måleinstrumenter
# En stabil og representativ koffert i aluminium; den rommer inn til 5 apparter pluss minst 4 antenner, små ting og tilbehør.
aluminium case K3
For safe storage and transportation of several instruments
* Measures: 52 x 40 x 21 cm
* With variable compartments
* Weight: 7100 g
På lager
Related Products
Frekvensfilter FF6 E til HFE 35C, HF35 og HFE 59B etc
FF6E er et lav- høy- og bånpass filter anbefalt for HF E 35C og HF E 59B. Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avlese.
# Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på instrumentet direkte verdien for denne strålingskilden Måler allpass;lavpass (1,1 GHz), høypass (1,1 GHz), GSM900, GSM1800, DECT,UMTS og WLAN Tetra og DVB-T.
Engl. Info:
Evaluates each radio service separately.
Additional features as compared to the FF6: The 50-60 dB suppression of unwanted frequencies is unequalled in this product segment. It allows for a precise analysis of the selected frequency ranges.
With its additional filters for TETRA-BOS, DVB-T, as well as high and low pass combinations applied at 1100 MHz this filter is especially suited for our E-type measuring devices (as from 27 MHz).
To be connected between the antenna cable and the antenna input socket of the measuring device (by the operator). Cascadable with all amplifiers and attenuators.
Also allows for a broadband measurement without additional transmission loss, which means the filter can remain attached to the device.
Perfectly shielded against interferences.
Possible exposures to sheath currents on the cable behind the filter can be additionally suppressed with the help of a free of charge modification of your HF-device.
Technical data:
Frequency Range: ALL / GSM9 / GSM18 / DECT / UMTS / WLAN / HP11/ TP11 /TETRA / DVB-T
Accuracy: Typical suppression of unwanted frequencies: > 50-60 dB, GSM1800 vs. DECT eff. 20-30 dB.
Power supply: 9 V NiMH battery, average time of operation: 8 hours, Low-Batt. indication, auto-power-off-function, mains adaptor, battery charger.
PM1 potensialfri stativ for LF måleapparat
Enkelt stativ (av tre) for å kunne gjennomføre potensialfri måling av lavfrekvente elektriske feltLF-Analyser ME3851A
for professional LF analysis
This device represents the low cost access to the professional, quantitative low frequencymeasurement technology. It is suitable for measurement certificates,
comprises all features of the ME3840B, however additionally offers:
* Responsivity increased by a factor of 10 (display range: 0.1 V/m to 0.1 nT)
* A NiMH battery, a battery charger and a power supply unit inclusive
* An AC- and a DC-output
* Increased reliability by the use of a test switching mode for the zero deviation
* Perfectly suitable also for potential-free measurements with the help of the potentialfree mounting for LF measurement devices
* Technical Data
Frequency Range: 5 Hz bis 100 KHz (compensated, better than -2 dB).
Measurement Range: 1-2000 nT V/m
0,1-200 nT V/m
Accuracy: precision : +/- 2 %, +/- 7 digits
Sensor: E-Fieldsensor for electrical LF- fields
H-Fieldsensor for magnetic LF-fields
Audio Analysis: An acoustic signal proportional to the field strength with ? Geiger-counter-effect? helps
identifying regions with increased exposure.
Stromversorgung: recharchable NiMH battery inside the meter
Outputs: AC- and a DC-output
Further Questions: 2 years warranty
Weight: 1050 g
VF 4 Variabelt Frekvensfilter for alle HF (HF35 oppover)
Demper 20 dB maks. Egnet for alle instrumenter fra HF35 og oppover.
VC 840 Set DigitalMultimeter med tilbehør
Digitalt multimeter med tilbehør
Sett egnet blant annet for kapasitiv måling av kroppspening. Innhold: Digitalt multimeter av god kvalitet, jordleding og håndelektrode.LF-Analyser ME3851A
for professional LF analysis
This device represents the low cost access to the professional, quantitative low frequencymeasurement technology. It is suitable for measurement certificates,
comprises all features of the ME3840B, however additionally offers:
* Responsivity increased by a factor of 10 (display range: 0.1 V/m to 0.1 nT)
* A NiMH battery, a battery charger and a power supply unit inclusive
* An AC- and a DC-output
* Increased reliability by the use of a test switching mode for the zero deviation
* Perfectly suitable also for potential-free measurements with the help of the potentialfree mounting for LF measurement devices
* Technical Data
Frequency Range: 5 Hz bis 100 KHz (compensated, better than -2 dB).
Measurement Range: 1-2000 nT V/m
0,1-200 nT V/m
Accuracy: precision : +/- 2 %, +/- 7 digits
Sensor: E-Fieldsensor for electrical LF- fields
H-Fieldsensor for magnetic LF-fields
Audio Analysis: An acoustic signal proportional to the field strength with ? Geiger-counter-effect? helps
identifying regions with increased exposure.
Stromversorgung: recharchable NiMH battery inside the meter
Outputs: AC- and a DC-output
Further Questions: 2 years warranty
Weight: 1050 g
Quasi-isotrop Ultrabredbånd-Antenne med GPS-boks
Boks som stativ for UBB antenne : kan da brukes som mottaker med GPS, i forbindelse med NFA serien. Med alle nodvendige kabler som tilbehør.Dette er den samme antennen som følger med eller kan kjøpes som tilbehør til flere av Gigahertz sine måleinstrumenter, men dette settet er tilpasset bruk sammen med spektrum analysatorer, NFA serien og GPS.
Quasi isotropic ultra broadband antenna UBB27-SA3
suitable for: spectrum analysers
UBB27_G3 incl. accessories designed for measurements with spectrum analysers_G3.
-DC input element, antenna mounted on plastic housing, including adapters and antenna cablel
Technical data
Frequency Range: 27 MHz to beyond 3.3 GHz.
Weight: 0,67 kg
VF 2 Variabelt Frekvensfilter – for å finne strålingskilden
Variable frequency filter (trap) VF2
convenient for any HF-Analyser from HF35C. For what-if analysis prior to shielding measures
* This filter allows the HF-Series of meters to determine the dominating frequency of the total pollution by suppressing the signal in question by a factor 100 (= 20 dB)
* Full text is currently only available in German
Høyfrekvens-forsterker HV10 (HF 58B, 59B)
Høyfrekvens-forsterker HV10 (HF 58B, 59B)
RF-preamplifier HV10_27G3 suitable for: HF58B, HF59B, HFE59B
Frekvensfilter FF6
FF6 er et lav- høy- og bånpass filter anbefalt for HF58B og HF58B-r. Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på inst.
# Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på instrumentet direkte verdien for denne strålingskilden.>Måler lavpass, høypass (1,1 GHz), GSM900, GSM1800, DECT,UMTS og WLAN.
Info Engl.
Evaluates each radio service separately
Additional features as compared to the FF3:
* The 50-60 dB suppression of unwanted frequencies is unequalled in this product segment. It allows for a precise analysis of the selected frequency ranges.
* An additional high pass filter applied at 1100 MHz helps differentiating in areas with high levels in the TV bands.
* To be connected between the antenna cable and the antenna input socket of the measuring device (by the operator).
* Cascadable with all amplifiers and attenuators.
* Also allows for a broadband measurement without additional transmission loss, which means the filter can remain attached to the device.
* Perfectly shielded against interferences.
* Possible exposures to sheath currents on the cable behind the filter can be additionally suppressed with the help of a free of charge modification of your HF-device.