Beskrivelse
TCO-LIGHT Sonde for potensialfri måling (TCO-standard)
TCO-LIGHT Sonde for potensialfri måling (TCO-standard)
kr 1 990
TCO-LIGHT sonde for potensialfri måling etter TCO standarden
Dette er en rimelig måte å sikre at en kan måle etter TCO standarden for lavfrekvente elektriske felt.
TCO Light benyttes sammen med lavf#TCO-compliant probe TCO-LIGHT. Simplifies the measurement of E-fields in line with the regulations at locations of difficult access, such as bedroom measurements or low-field electrical installation inspections.
* Basic type
På lager
Related Products
Høyfrekvens-forsterker HV10 (HF 58B, 59B)
Høyfrekvens-forsterker HV10 (HF 58B, 59B)
RF-preamplifier HV10_27G3 suitable for: HF58B, HF59B, HFE59B
Frekvensfilter FF3
FF3 er et bånpass filter tilpasset instrumentene HF35C og HF38B. Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på instrume.
Til HF 35 C, HF 38 B, HF 58 B, HF 59 B.
#Service-specific frequency filter FF3 Recommended for: HF35C, HF38B. The service specific filters always only show the preset radio service, and suppress all other frequencies.
Evaluates each radio service separately
* To be connected between the antenna cable and the antenna input socket of the measurement device (by the operator).
* Cascadable with all amplifiers and attenuators.
* Also allows a broadband measurement without additional transmission loss, which means the filter can remain attached to the measurement device.
* Comprises the most common sources of radiation.Very good selection of the chosen radio services.
* Possible exposures to sheath currents on the cable behind the filter can be additionally suppressed with the help of a free of charge modification of your HF-device. Please do not hesitate to contact us.
Frequency Range: ALL / GSM9 / GSM18 / DECT / UMTS / WLAN
Accuracy: Typical suppression of unwanted frequencies : > 25-30 dB, GSM1800 vs. DECT eff. 20-30 dB.
Power supply: 9 V battery
Silikonhylster for LF og HF Måleapparat, gult
En stabil og representativ koffert i aluminium; den rommer inn til 5 apparter pluss minst 4 antenner, små ting og tilbehør. aluminium case K3 For safe storage and transportation of several instruments * Measures: 52 x 40 x 21 cm * With vEn stabil og representativ koffert i aluminium; den rommer inn til 5 apparter pluss minst 4 antenner, små ting og tilbehør.
aluminium case K3
For safe storage and transportation of several instruments
* Measures: 52 x 40 x 21 cm
* With variable compartments
* Weight: 7100 g
Frekvensfilter FF6
FF6 er et lav- høy- og bånpass filter anbefalt for HF58B og HF58B-r. Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på inst.
# Med dette filteret er det enkelt å finne hvilke strålingskilder som er dominerende. Ved hjelp av en glidebryter velger du den kilden du er interessert i (f. eks. DECT) og avleser på instrumentet direkte verdien for denne strålingskilden.>Måler lavpass, høypass (1,1 GHz), GSM900, GSM1800, DECT,UMTS og WLAN.
Info Engl.
Evaluates each radio service separately
Additional features as compared to the FF3:
* The 50-60 dB suppression of unwanted frequencies is unequalled in this product segment. It allows for a precise analysis of the selected frequency ranges.
* An additional high pass filter applied at 1100 MHz helps differentiating in areas with high levels in the TV bands.
* To be connected between the antenna cable and the antenna input socket of the measuring device (by the operator).
* Cascadable with all amplifiers and attenuators.
* Also allows for a broadband measurement without additional transmission loss, which means the filter can remain attached to the device.
* Perfectly shielded against interferences.
* Possible exposures to sheath currents on the cable behind the filter can be additionally suppressed with the help of a free of charge modification of your HF-device.
VC 840 Set DigitalMultimeter med tilbehør
Digitalt multimeter med tilbehør
Sett egnet blant annet for kapasitiv måling av kroppspening. Innhold: Digitalt multimeter av god kvalitet, jordleding og håndelektrode.LF-Analyser ME3851A
for professional LF analysis
This device represents the low cost access to the professional, quantitative low frequencymeasurement technology. It is suitable for measurement certificates,
comprises all features of the ME3840B, however additionally offers:
* Responsivity increased by a factor of 10 (display range: 0.1 V/m to 0.1 nT)
* A NiMH battery, a battery charger and a power supply unit inclusive
* An AC- and a DC-output
* Increased reliability by the use of a test switching mode for the zero deviation
* Perfectly suitable also for potential-free measurements with the help of the potentialfree mounting for LF measurement devices
* Technical Data
Frequency Range: 5 Hz bis 100 KHz (compensated, better than -2 dB).
Measurement Range: 1-2000 nT V/m
0,1-200 nT V/m
Accuracy: precision : +/- 2 %, +/- 7 digits
Sensor: E-Fieldsensor for electrical LF- fields
H-Fieldsensor for magnetic LF-fields
Audio Analysis: An acoustic signal proportional to the field strength with ? Geiger-counter-effect? helps
identifying regions with increased exposure.
Stromversorgung: recharchable NiMH battery inside the meter
Outputs: AC- and a DC-output
Further Questions: 2 years warranty
Weight: 1050 g
K3 Aluminium Koffert for inn til 5 måleapparater (stødig)
Stødig og god aluminiumskoffert hvor du får plass til inntil 5 måleinstrumenter med nødvendig tilbehør. Et svært godt alternativ for den profesjonelle måletekniker!
# En stabil og representativ koffert i aluminium; den rommer inn til 5 apparter pluss minst 4 antenner, små ting og tilbehør.
aluminium case K3
For safe storage and transportation of several instruments
* Measures: 52 x 40 x 21 cm
* With variable compartments
* Weight: 7100 g
.
Silikonhylster for LF og HF Måleapparat, sort
Silicone hylster til 3D, LF(ME) og HF seriene med instrumenter. Gir en god støtbeskyttelse for instrumentet ditt!
Farve: sort
STS 1 Elektrostatiksensor
Måleinstrumenet for å måle elektrostatisk oppladning på f. eks. bildeskjermer, teppegulv etc. Slik oppladning påvirker lufkvalitet etc.
Måleområder: 2000V og 20 KVLF-Analyser ME3851A
for professional LF analysis
This device represents the low cost access to the professional, quantitative low frequencymeasurement technology. It is suitable for measurement certificates,
comprises all features of the ME3840B, however additionally offers:
* Responsivity increased by a factor of 10 (display range: 0.1 V/m to 0.1 nT)
* A NiMH battery, a battery charger and a power supply unit inclusive
* An AC- and a DC-output
* Increased reliability by the use of a test switching mode for the zero deviation
* Perfectly suitable also for potential-free measurements with the help of the potentialfree mounting for LF measurement devices
* Technical Data
Frequency Range: 5 Hz bis 100 KHz (compensated, better than -2 dB).
Measurement Range: 1-2000 nT V/m
0,1-200 nT V/m
Accuracy: precision : +/- 2 %, +/- 7 digits
Sensor: E-Fieldsensor for electrical LF- fields
H-Fieldsensor for magnetic LF-fields
Audio Analysis: An acoustic signal proportional to the field strength with ? Geiger-counter-effect? helps
identifying regions with increased exposure.
Stromversorgung: recharchable NiMH battery inside the meter
Outputs: AC- and a DC-output
Further Questions: 2 years warranty
Weight: 1050 g